Ide Hard Drive Jumper Settings Western Digital

If your existing hard drive is confi gured as master then set your new hard drive to slave. The jumper pins on block j8 need to be configured for the dual installation.

Https Eshop Macsales Com Tech Manuals Idehdsettings Wd72 Pdf

4with a pair of tweezers or needle nose pliers place the jumper a little plastic thingy across the correct pair of pins either master or slave.

Ide hard drive jumper settings western digital. If you have a dual installation two ide drives you must designate one of the drives as the master and the other as the slave. It will work fine without them on pretty much any computer made in the last ten years. Eide hard drive jumper settings.

Western digitals instructions for jumper pin settings on some sata hard drives. Most of the options above are included for the sake of backwards compatibility. Information on setting jumpers western digital hard drives eide disks all caviar drives have a jumper block j8 located between the 40 pin ide connector and the power connector.

Installing the new drive as the primary master drive. If youre replacing an ide drive set its jumpers to match the old drives settings either master or slave. These jumpers select options physical hard disk detection.

If you have diffi culty locating this information visit the hard drive manufacturers website. All hard drives in a csel compliant system have the jumpers set in the same position. All caviar drives are factory set for the installation of cable select.

Wd eide hard drives are factory set with cable select csel jumper settings. We would like to show you a description here but the site wont allow us. If your existing drive is set for cable select then set your new drive to.

The csel jumper setting protocol requires the use of a special interface cable. Refer to figure 1 for an illustration of all jumper settings. Then configure the jumper on the other ide device as slave.

If you are connecting your drive as the master drive on the cable with another ide device move the jumper shunt on the drive from pins 1 2 to pins 5 6. Unless you have need of those specialty settings you can safely ignore the jumper pins on your drive. Most hard drives have a schematic either silk screened onto the case of the drive or the schematic is on a label near the jumper pins.

Pcb 2060 701314 001 Rev A Br From Wd3200jb 00kfa0 Western

Western Digital Caviar 33100 Wdac33100 00h P N 99 004217 000 Etsy